Search results

So after exhausting all posibilities, I decided it was probably like all the other graphtecs I read about. something wrong on the mainboard. Staring in the face of most likely paying 450.00 + labor or more for a replacement main board, I decided I would dig deeper into testing the main...

I've had the plotter for over 2 years. Used very lightly, meaning I tried to start a side business doing vinyl graphics and it didn't take off. Anyway, I'd say it has probably been used/ran 70 times. I dont get error codes except for only the x position alarm. I'm basically putting a 12x12 inch...

Yes,I have, I have also upgraded the firmware. Opened the side caps to see if the motor was obstructed/dirty. Checked for bad capaicitors/checked for loose connections on the pcbs/main boards, etc. Today I went back and looked at the sensors. There is a 'docking' as i would call it sensor...

Hi all , Just joined and am new here. I've got a graphtec cutter i've been on and off trying to fix for about a year. Scouring the web for a solution. no dice, but some interesting leads. I'm a hobbyist, so i've never really put the thing through the demands of daily use. Just to start off I'm...