I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
So I've just checked out the LED's +24V, +15V, -15V and +5v are all lit green. The green LED's for SPIN#1 and SPIN#2 do not light at all. The two red ones (Amp Fault and Emgcy Sw Fault) are both off although the Red Amp Fault one lights for a second or two during start up. Start up beeping was...
Thanks Chadorama - All is locked up here for the night now, but I'll check out the LED's and the beeps in the morning - to be honest I never noticed if the beeps were different or not. I'll could meter the serial lead but don't have a diagram for it - do you know if its just straight thru...
StarSign - yes I've hit the emergency stop but unfortunately it did not cure the issue .... I've went on to "hit" every other part too, but that's from pure frustration rather than technical prowess o_Oo_O
When I send a job the router behaves exactly as if the spindle is running - no errors.
In fact once I start the job the display changes on the inverter and if someone hits the local/remote button on the inverter and the hits run the spindle will run and the job will complete as normal - except...
We have a sabre 408 with spindle motor. The spindle motor is not turning on, either when a job is sent or when selecting motor warm up.
When I open the motor control cabinet the inverter display says CALL, when I select motor warmup on the keypad the display on the inverter changes to 333.3 I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.