I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hi Robert
The error (wrong head) means that the head cables were not connected correctly. See the attached photo to see the correct way to connect them.
and the head is an Epson Model, Roland Mutoh or Mimaki they use the same Roland head, it is not a problem for whoever sells it.
Hi
It is not related to anything of the 220V voltage in the configuration there is an option that says external heater you have to turn it off otherwise it will always send you an alert that it is not reaching the temperature.
yes you can order without the memory board and i send you the video to change the head id. you can download here:
https://we.tl/t-AAMH9QWp5k
and try first to change the slider if dont work let me know and we try with the firmware.
i can send you the manual to replace any of this printheads with and withput memory board. i worked 7 years in mimaki printers.. so i have any firmware and any manual.
that's strange the slider board is in charge of sending the voltage signal to the head, it reads the encoder and some sensors. but if the printer turns off I don't think it's the slider .. but how does the printer turn off??? just do the process to turn off or are you just printing and out of...
Hi
what you can do is return to factory settings. enter to funcion then setup then user 1 then setup reset and you would return to the factory settings.
Hi in maintennace there is an option it said routine setup then cleaning change the time for 8 hours try it... or go to setup reset and all the values return a factory settings. and do the drop post correct and start like new.
When using 8 colors the printing speed decreases ,,, for higher speed it is recommended double CMYK. but here you can downland some profiles since I'm reviewing and there is no 540X720 profile see link bellow...
For the following procedure you need a syringe I send you a link so that you can download the video if this does not work, I think you should change the head, or try to inject the head directly, but for this procedure experience is needed.
Download link
https://we.tl/t-kiSUYjzgMG
Hello
Try to do the nozzle wash function for 30 minutes ending with a hard cleaning. and send me a photo the nozzle test ..
If it does not improve, we will do a check pattern from the service.
Hello
this problem seems to be an ink problem .. which ink are you using ????
Could you send me a picture of your nozzle test ..If the nozzles are deviated you must first correct it since this cannot be fixed with calibration.
In my opinion, hybrid printers are not super reliable since a bad process can damage the printing or the cut and have an optimal performance of both.
I highly recommend having two machines, one for printing and a cutting plotter so when it fails you don't lose two machines.
When a printer does not turn on it is because the mainboard transistor is burned out and for protection it does not allow the printer to turn on. if you replace this transistor you can re use the old board.
of course changing the mainboard you will solve the problem .. but first you must...
Hello
okay when you have ink some of the connections inside the head are not allowing the cable to connect properly. That's why it prints a single color in full ... what I have done is clean the inside of the head with alcohol to remove the ink and let the cable have a good contact ...
You...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.