• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

cjv 150-75

  1. Mimaki CJV150 No Magenta on Right side

    Hi, Basically I had an issue on my cjv, I lost a couple of channels did the following: New cap New Pump New damper (both colours went into that damper) Got the engineer out discovered there was a small dint on the head Ordered this...
  2. Need Help Mimaki CJV 150-75

    Hi everyone, I’m looking for some help with my printer. I purchased a CJV150-75 that has sat for about a year. It will not print,expired ink,not stored properly and I’m sure the head is completely clogged. It shows no errors other then the expired ink. I was hoping someone could give me some...
  3. Mimaki CJV150 Cross Contamination Help

    To cut a long story short our cjv150 was dripping ink onto the media last week. We replaced the dampers and capot and the problem was resolved. This week we now have cross contamination in the yellow channel. This is present as soon as we turn the machine on after it has been left overnight and...
  4. Mimaki Grainy Prints

    Hi, Is it normal for certain colours too look slightly grainy like this. Machine is 2 year old running cmyk x2 the engineer who installed it said it’s normal on certain colours. If we print a cmyk pattern the colours are solid with no banding. We run prints on 1440 with 16 pass any lower the...
  5. Mimaki CJV150 station height and cap adjustment help

    I was just wondering if anyone could give me some advice regarding the cap top adjustment. In the service manual it states the pin which runs up and down the track taking the cap top up and down should be 3mm to the centre from the highest point. On our machine if I adjust it to what is stated...
  6. Need Help Print or Cut, But not Both

    Hello All. I am running a Mimaki CJV 150-75 with CCMMYYKK SS21 inks. For the last year or so things have worked fine without much issue. Today we hooked up a Graphtec Plotter and it runs fine. Now any time I try to run a Print/Cut job on the Mimaki it fails. PS Interpreter Panic Error. I can...
Top