cjv150-130

I would like to know if anyone has parameters for a cjv150-130 using ES3 inks, atech guy played in my parameters working on my printer, and it's a bit messed up keeps throwing up a code, even after the problem was fixed. I'm from the Caribbean so paid a guy to remotely update my firmware. so...

To cut a long story short our cjv150 was dripping ink onto the media last week. We replaced the dampers and capot and the problem was resolved. This week we now have cross contamination in the yellow channel. This is present as soon as we turn the machine on after it has been left overnight and...

Hi. To cut a along story short we have refurbished a civ150 and adjusted the station height to 5mm as per the service Manual. The problem is though that when we adjust the cap position the slider should be 3mm per the service manual but ours has to be about 5-6mm before the head locking latch...

Hello. I use a Mimaki CJV150-130 in my work. In my work we use this machine to do some signs, only for the company purpose. So we buy new INK cartridges, in this case we buy SS21 ink, but we previously use BS4 ink, and now when we try to put the machine running appears an error in the boot "INK...

I wanted to share a very bizzare problem that I had in case anyone else runs into the same issue. I have a Mimaki CJV150-130 printer that is about 2 1/2 years old. I recently bought a new computer and I use Flexi 12 subscription service. So I downloaded the newest version of Flexi and...

I'm attempting to install Rasterlink 6 on a new computer - have un-registered original computer, followed all the same install instructions as original computer. For some reason Rasterlink 6 is not allowing me to add our CJV150-130. Previous installations on other computers have gone fine, but...