• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

head height

  1.

    Mimaki JFX200 Head Height / Bed Leveling Issue

    Hey guys, I'm looking for a little guidance here. We got a JFX200 a few months ago, and ever since we haven't been able to get consistent prints on the bed. When we do a head height check across the bed, it's all over the place. I've had multiple techs in from the distributor we purchased it...
  2.

    Strange lines appearing in middle of prints! Xc-540

    Hi again all, I have a strange one for you. XC-540. After a good run of say 20m, i started noticing strange lines appearing in the middle of the prints. It is not to the left or the right, just in the middle. I adjusted the head height to low and they dissapear. When I put the head height to...

  3. Maintenance and Service HP9000 cariage height

    :bushmill:I have just replaced a failed bearing on a HP9000 cariage. Some washers were used to ge the headheight more or less correct. any one know what the correct head height should be?:bushmill:
Top