• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

mimaki cg 160fx

  1. Mimaki CG 160FXII cutter issue?

    Have a Mimaki CG 160FXII cutter, from 2013. Just started making clanking noise when doing horizontal cuts, and on rounded corner rectangles it cuts opposite corners at an angle instead of rounded. Not sure if belt issue or motor issue, no idea honestly.
    • Hagerty
    • Thread
    • bad cuts belt cutter mimaki mimaki cg 160fx mimaki cg160 fx motor noise plotter
    • Replies: 0
    • Forum: Newbie Forum

  2. Mimaki CG160 FXII - Cut Through?

    Hi Guys! Does anyone have any special tips on (if possible) using the CG160-FXII to cut through the media fully rather than contour cutting? I'm currently using the plotter to only do cut contours, but due to a job that has just come in, I'm going to have to hand cut 500 square stickers by...

  3. Need Help Mimaki cg 160fxII Firmware file

    I just purchased a Mimaki cg-160fxII from a private party. I couldn't get my finecut, Illustrator software to send a file to the plotter. It is communicating with the plotter just won't send a cut file. I spoke with Mimaki and they said I needed to do a firmware update. They took it no further...
Top