• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

#plotterissues

  1. Cut force with Roland VP-540 and Onyx

    Using Onyx Thrive v24 and cutting on a Roland VP-540. When I send the print back through via CutServer, the force defaults to 60g. No matter what I set it to in Onyx, even setting to use the machine defaults, it always goes back to 60gf. Even the cut speed goes back to 30cm/s. Up speed does not...

  2. Need Help Graphtec Cutting in different depths at X Axis

    Hello! We are having an issue with our Graphtec 8600, the knife is cutting deeper close to the origin point in X axis. Basically, it cuts deeper in the first 20″ of the axis, and the remaining cuts as it should. Anyone experience that before? On another topic, we are quite frustrated with the...

  3. Need Help Flexi 12-Plot command after cuttest

    Hi. We have recently upgraded our Flexi 10.x licenses to Flexi 12, and are experiencing an issue with our plotter Summacut T140 series. In Flexi 10, whenever we had performed a cuttest on the pressure for the tangential knife, our plotter would feed the used amount of vinyl before starting...
    • 2ny
    • Thread
    • Replies: 4
    • Forum: Flexi
  4.

    Need Help Help with uneven plotting

    Hey everyone, I could not find a related thread so please excuse me if this has been addressed in the past and I missed it. I have been experiencing inconsistent plotting on our Mimaki CG-160FX These jagged edges and offset counters occur in every output but it always in the same place. The...
Top