I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I've been trying for a while to get an older UCJV300-160 up and running again. My current problem is ink pooling on the underside of the left printhead ( stage right ). I'll call it HEAD 1.
So far, I've replaced the following:
1. All the ink lines / tubes ( MP-M018909 )
2. Cap bases (...
I've recently acquired a used Mimaki UCJV300-160 and it has started acting up. I made the mistake of leaving town for a few months without a maintenance plan in place for it. Since I've been back, it has developed a handful of errors that I'm hoping you clever folks can help me resolve. The...
Hey Guys
got a solid deal on a jv33 that had been sitting. I have been soaking the head for the past week adding solution every other day. Using a syringe this morning I used a little pressure through ech chamber on the manifold lines with pretty great success! while doing all of the manifold...
We've had this cutter for a few months now and once set up has been great.
Just lately we've had an issue where we set the pressure correctly then part way into the job it will increase the knife pressure so much it ruins the job.
Like it would cut through the backing if we didn't have the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.