sabre

I'm a newbie to this machine and had it working for a short while. Recently, when turning on the machine I got the above error. I also have an illuminated Red LED for AMP FAULT. All the green LEDs are lit apart from SPIN #2 My background is in embedded systems (mix of electronics and software)...

I have a Sabre 404 that I need to sell or part out. It was a good running machine that I just took out of service a couple months ago when I upgraded. It was under warranty until the end. I am keeping the software. This machine is old but was still running good. I think, as old as it is, it...

Hey! I have a 408 Gerber with vaccuum board, as for now the original waste/spoil board is pretty much non existent, it's like 1-2mm left and many places the bare alu boards under are shown. So! It's about time to get it changed, I've read a lot of people using MDF without even routing the...

When it rains... I have recently began receiving a CPFO error on my Sabre. It was intermittent and would eventually go away. Now that I have several jobs I need to router, it has decided to stay. Any advice?

Anybody out there using Enroute to V carve signs on a Gerber 408.? We are using Enroute version 3.2 to run our Gerber Sabre 408 and getting inconsistent results. The routing depths are off. I realize that substrate thickness inconsistencies can effect the V-carve but not to extent that we are...

We have a Gerber Sabre 408 router that has started to produce rough edges on routed pvc. We are using Enroute4. We have also noticed that the gantry is loose and we can move it by hand about a 1/16" in both directions when the table is idle. Has anyone had issues with "chatter" in the gantry...

So it's been at least 10 years since I've had to replace the sacrificial boards on my Gerber Sabre 408. I've drilled & pocketed them and find myself stuck on the milling of the material surface. I keep getting "Job Exceeds Table Boundary X: 000.002in Y:000.000in" :frustrated: TIA