• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

sensor error

  1. Need Help My ol' Roland SP-540v can't sense the left pinch roller. What kind of sensor is involved?

    HI THERE, EVERYONE! :) My ol' Roland SP-540v can't sense the LEFT pinch roller. The carriage just skips right by it. going all the way over to the left side and returns to the station. It says "invalid" left pinch roller position BUT IT IS DEFINITELY right smack dab in the middle of where it's...
    • crgrove
    • Thread
    • leftpinchroller sensor error
    • Replies: 4
    • Forum: Roland

  2. Question Length limit of print & cut on Graphtec?

    Hi ya all, Having a print & cut issue, sending the file that is about 8ft long, laminated to the Vinyl Express (Graphtec). Have plenty of space in the sides, etc. but it is refusing to read the last set of marks at the bottom of the file. Tried putting some matte scotch tape, etc., just in...

  3. Question Fc8000 E04010 Error

    Has anyone ever replaced the mark sensor?? I recently did and almost have my machine cutting again, but i keep getting this "EO4010 ARMS, MARK SCAN ERROR, EXEED CUTTING AREA DURING +X DETECTION" I've cut a few other small print successfully, but this particular print is larger and printed...

  4. Roland cx24 Old Faithful not so faithful right now.

    My Roland Camm1 Cx-24 cutter is about 15 years old and displaying "Senor Error" I have tried to reset cutter by turning off power but I keep getting same message. Any help or suggestions would be appreciated.
Top