technique

HI, So I am getting into wraps on small areas... How would you go about installing a bottom wrap on this door with sharp body lines? I have done one before with a hinge install to the right but that came out okay but not perfect. How would you go about installing this? Material 3M IJ...

This partial wrap is 4 years old. We used Oracal 3751 with 290 Laminate. Both sides of the vehicle were printed and installed from the same rolls of materials. Installed using the same technique. Driver's side is wrecked, passenger side looks like normal wear-n-tear after 4 years. Anybody got...

I have stumbled on this somewhat in the past. I'm looking for a better way to installing a 5 inch thick stripe, and then expands out to 12inches thick and its 25 foot long on an aluminum corrugated vehicle. I want to improve my present technique which takes to long, and has too many drum...

I've searched the forums and haven't had any luck finding an answer. high quality photos on very thin aluminum seem to be getting popular. It seems to me they could be printed directly to the aluminum with a flatbed printer or possibly dye sub and heat applied and there are probably other...

Hello everyone! First off, I want to tell everyone on this forum how amazing you all are. Everyone is so knowledgeable and helpful. I have never seen a sign site with such community. I've only been in the sign industry for about 5 months, but with the help of everyone here, I can proudly say...