1/2" PVC joint

[mpn]

What would be the best method to join 2 pieces of pvc to create an 3'x11' panel?

These will be flush mounted to the wall & have a digital print overlay.

 

[Z SIGNS]

Could you use ACM ? comes 12' no seams

 

[visual800]

What Z Signs said or you can take 1/8" pvc and use pvc primer and cement to glue both panels down to to for a flush fit. Make sure you use 1/8" on anchor areas to keep panel true to wall

 

[mpn]

What Z Signs said or you can take 1/8" pvc and use pvc primer and cement to glue both panels down to to for a flush fit. Make sure you use 1/8" on anchor areas to keep panel true to wall

Z Signs: I don't know where to source 1/2" ACM and if so, I need a white core.

Visual, I'm thinking this will be the way to go.

What do you guys think of a 3" wide half lap with the PVC? Say 2 5.5' pieces glued together or is this over thinking it?

 

[fixtureman]

I would laminate 2 6mm together with staggered joints. 4ft on one end and the 4 ft on the other