Automatic Mark Detection Issue

[QuickSilver2605]

I am having an issue with my FC8000-160 Not automatically looking for and read the registration marks on my print/cuts.

Before I would simply print through Onyx 10 and use their cut-server, I would just align the tool to the first mark, hit "cut now" and it would do everything else automatically.
Just like this



Now it is giving me this screen whenever I hit "cut now" and I have to hit enter on the Graphtec also before it will read the marks and cut.



Any idea what I can do to make it read all marks and cut when I click "cut now"?

 

[StarSign]

Check all of your settings, in Onyx and on the plotter. Maybe someone jacked with it.

 

[QuickSilver2605]

I've checked a few settings, but my system was setup for me and I'm not sure, if something changed, what to even look for. Also on my most recent prints, the arrow showing the feed direction and the barcode have been aligned to one side of the print when they used to be centered.

 

[StarSign]

In the RIP are you sure you selected the correct plotter

 

[QuickSilver2605]

As far as I can tell the plotter is selected correctly. It's a graphtec fc8000-160

 

[P Wagner]

I am having an issue with my FC8000-160 Not automatically looking for and read the registration marks on my print/cuts.

Before I would simply print through Onyx 10 and use their cut-server, I would just align the tool to the first mark, hit "cut now" and it would do everything else automatically.
Just like this

View attachment 94161

Now it is giving me this screen whenever I hit "cut now" and I have to hit enter on the Graphtec also before it will read the marks and cut.

View attachment 94162

Any idea what I can do to make it read all marks and cut when I click "cut now"?

When Onyx released the 10.2x product, with the Graphtec FC it will automatically search for the marks after sending the job. Onyx 10.0 and 10.1 releases prompt the user on the Graphtec to move to the first mark then hit Enter on the plotter.