banner material on l25500

[jmag215]

What is everyone using for banner material on the l25500. I have been doing vehicle wraps for about 4 years now and would like to get setup to do banners. Any help or suggestions on equiptment, tools or knowledge would be greatly appreciated

 

[ddarlak]

Arlon 313, stay away from ultraflex

 

[tattoo.dan]

i like forward

 

[jmag215]

Arlon 313, stay away from ultraflex

Do I use the gloss or matte? Do I need to laminate with anything and what about the edge holder things? Is the 63" to wide?

 

[Niun]

We use Grimco's Key Banner and it has been working just fine on our L25500 and our 360

 

[BigfishDM]

Make sure its a 1000x1000 and not a 500x500 denier material. The latex is a little picky when it comes to banner but I have found many brands that work great and they all happen to be 1000x1000.

 

[BigfishDM]

Do I use the gloss or matte? Do I need to laminate with anything and what about the edge holder things? Is the 63" to wide?

Depends on what your clients prefer, gloss looks better IMO but you can have glare issues outside. You should have matte and gloss on hand, banner is cheap so it wont cost an arm and a leg to hold one roll of each. Edge holder things are Grommets (or at least Im thinking that's what you mean lol) You can get a hand unit from Home Depot to start. 63" isn't too wide at all and will cover lots of sizes. You also want to get some banner tape so you can make a clean presentation of your product.

I have a branch in SLC is that far from your location? I could send a rep over to visit with some banner samples if you like.