Black Print Head Alignment

[schurms]

Have a Mutoh Junior 38. The print head went out of adjustment. I manually adjusted it to the point of being off about 1/128 off side to side. How do you get this set closer in the software in the printer?

Bruce

 

[RG]

Hi, Bruce. Do you have the Maintenance Manual? If not, you can get it here: http://www.ajh-designs.com/files. I had to replace my printheads about a year and a half ago, so I can't remember exactly what to do. There is a series of test prints to do and then you look closely at them and input changes through the control panel. The manual certainly isn't comprehensive or very well written, but it can get you through this. Good luck!