Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

BN-20 Oralite 5650RA

Discussion in 'Roland' started by Aeron, Dec 22, 2020.

  1. Aeron

    Aeron New Member

    1
    0
    1
    Mar 9, 2020
    Oregon
    I've been researching and I'm at a loss. I bought about $300 worth of Oralite 5600 to print reflective decals on my BN-20. The roll is cut the same width as the 3165 Oracal rolls I use. My issue is when I load the 5600 roll when the printhead gets to the end, it comes up with a loading error. The rollers are on the vinyl and over the rough areas of the roller bar so it has grip. If I take out the reflective material, without adjusting anything, and load regular material it comes up ready to print. Even taking it out and covering the sensors, its ready to print. It only comes up with the loading issue if I have the reflective material loaded. I've loaded different sizes in case it was the width, and there is still a loading issue. I use much thicker reusable wall vinyl and there is no loading issue so it's not the thickness of the vinyl. I'm completely lost. I've read posts of others using this same material here with the BN-20. Am I missing something?
     
    Tags:
  2. IsItFasst

    IsItFasst Member

    385
    12
    18
    Jan 16, 2008
    USA
    That is odd. Not sure what is different on the BN-20 compared to the Rolands we use (SP and VSi) but we print on 5600 all the time without any issues. Even crop marks read fine on it.
     
Loading...
Similar Threads - Oralite 5650RA
  1. Jules
    Replies:
    5
    Views:
    901

Share This Page

 


Loading...