Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

can't get job to print

Discussion in 'Roland' started by brad daggy, Jan 11, 2008.

  1. brad daggy

    brad daggy Member

    56
    0
    0
    Aug 28, 2007
    Here is what is going on: I have a xc-540. I am printing a job with the following layout: Custom roll,
    Get media width- 53.58".
    Scaling: 1202%
    w- 293.81
    H- 104.67

    Tile Spacing

    Clip and Tile
    Tile size- Size- custom cut
    w-49.68
    H- 104

    Overlap

    Topleft
    size: .75

    When I go to Print and get this error messege: current media width is smaller than required size for job. Do you want to continue?

    What goes?
     
    Tags:
  2. Goodgirl

    Goodgirl Member

    34
    0
    0
    Oct 16, 2006
    Do you also have it set to print registration marks?
     
  3. DRPSignsNGrafix

    DRPSignsNGrafix Very Active Member

    If it's set to print registration marks as well that's another 2 inches of material needed.
     
  4. brad daggy

    brad daggy Member

    56
    0
    0
    Aug 28, 2007
    No, i figured it out myself. Thanks.
     
Loading...

Share This Page

 


Loading...