CG-130fx Wont detect targets

[Hanks Signs]

I have had this plotter for 5 yrs and all of a sudden it wont detect the printed target to cut decal anyone else had this problem???

 

[Hanks Signs]

IT says ERR36 MRKdetect

 

[thewood]

Have you cleaned the sensor?

 

[nashvillesigns]

there is a chance the "Eye" is clogged. spray it with a air can. you need to make sure also, that your settings are correct. (of course, this varies. either way, make sure your print marks are the same size and diameter as the settings on the cutter under settings for "mark". of course, don't print on holographic material. this never works...

 

[MikePro]

are your marks near the edge of the page? sometime my cutter won't detect if my pinch wheels are too close to the marks, thus the cutter not being able to find them within its known margins.