CJV30-130 Cutting Issues

[jrpaceys]

Good Morning All,

Have been having some issues with out CJV30 lately, In a Cut3 - the start top orientation is slightly off. Leaving small portions uncut, I have tried every adjustment in book, and still not getting where I need to be, have even replaced a blade holder and blade but to no help. If you have had any experiences with this any help or suggestions would be greatly appreciated. !

Thanks Again

 

[Out There]

So if you cut 3 separate letters all them will a section ucut?

If this does not happen it cut mode 1 or 2 i would reset setting in cut 3 and see if it helps.

I've had this issue before, but for me I switched cutting blades and had the wrong blade height.