• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

CoCut and Summa T750

letterman7

letterman7

New Member
Recently I had to re-load all my software and drivers due to a computer crash a few months ago. Since then, my Summa, driven off CoCut out of Corel 10, was working fine. It had always "forwarded" a set length of vinyl before it actually cut (which was a little bit of a pain) but today, setting up a 20' plot, it ran out more than 20'. Somewhere I had read about changing or shutting off that item - but I can't find it anywhere. Anyone have any clue where to look for that setting?

Thanks!
Rick
 
letterman7

letterman7

New Member
Problem fixed... it's always the simple stuff. The checkbox next to 'sort in x direction' wasn't ticked. Checked, and no more shuffling vinyl.
 
You must log in or register to reply here.
Top