Rage Wraps
New Member
Ok, this is getting ridiculous over here. I have a trailer I am printing out and I am setting it up to be tiled. I am using 54" material and I bring it into the layout tab. No I setup how many tiles I want it to be and the right and left overlap at .5"
(Side no does anyone leave the top and bottom overlap set at .5" also or do you set it to 0"?)
Then I hit the OK button and it freezes up on me every time. I am just going to have to cut out all of my panels on this one and print them separate. Any suggestions?
(Side no does anyone leave the top and bottom overlap set at .5" also or do you set it to 0"?)
Then I hit the OK button and it freezes up on me every time. I am just going to have to cut out all of my panels on this one and print them separate. Any suggestions?
