Hello everyone,
I would like to ask help, whom has experience about the compensation settings.
Is there any possibility to count it that values? I have couple of settings which are
close, but just based on printing and measuring after the calendering.
I would like to do more accurate. And determine or count on longer size.
How is that possible with the same settings, same image size, same material
end it up one of the image 5 cm smaller?
My printer is a jv5-320ds and for rip using Caldera 11.01.
Thank you in advance any helpful advice.
Best regards,
Lajos
I would like to ask help, whom has experience about the compensation settings.
Is there any possibility to count it that values? I have couple of settings which are
close, but just based on printing and measuring after the calendering.
I would like to do more accurate. And determine or count on longer size.
How is that possible with the same settings, same image size, same material
end it up one of the image 5 cm smaller?
My printer is a jv5-320ds and for rip using Caldera 11.01.
Thank you in advance any helpful advice.
Best regards,
Lajos
