Cutting only - How can I print a target?

[stitchup]

This might be a stupid question but .......

I've been asked to produce 1200 screen protectors for some handheld radios. At a squeeze I can get about 10 cuts across the width of the vinyl.

As I don't need to print anything as part of the design I don't get a target to line up the bomb sight. How can I get one to print or perhaps I don't need one?

John

 

[WhiskeyDreamer]

not sure why you'd need a target if you're only cutting....printing a target could possibly screw up the cut if it's outside the 11.7 edge limit

 

[GB2]

You don't need a target for cutting only. The target is only for print to cut registration.

 

[stitchup]

Great. Thanks for the replies guys.

When I use my raphtec plotter I have to set the start point for cutting = Set Origin. I thought the GS15 plotter would need something similar!

Cheers