Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CX 24 Error

Discussion in 'Roland' started by mbarden, Oct 17, 2006.

  1. mbarden

    mbarden Active Member

    596
    2
    18
    Oct 1, 2006
    Iowa
    Hi Folks,
    Tried to fire up my used CX 24 and after powering it on I get a "sensor error" message on the display. Checked the error messages in the documentation and there was no reference to the error message. Any ideas?

    Thanks
    Mike B
    Big River SIgn
     
    Tags:
  2. Sticker Dude

    Sticker Dude Member

    397
    0
    16
    Mar 26, 2006
    Florida
    you bought it used? thats probally why they sold it
     
  3. The Big Squeegee

    The Big Squeegee Major Contributor

    4,954
    107
    63
    Oct 10, 2005
    Lawton, OK, USA
    Check to make sure the rollers are where they are supposted to be. If they are out of their zones you will get an error.

     
    Last edited: Oct 17, 2006
  4. mbarden

    mbarden Active Member

    596
    2
    18
    Oct 1, 2006
    Iowa
    Thanks Folks,
    Am currently in the PC technician business so I opened up the case and found that one of the ribbobs was dis connected from the chip borad connected to the face of the cutter. I re connected the small ribbon and after powering back up I got no error and normal operation. How's that for a run-on sentence.
    Thanks for the input.
     
Loading...

Share This Page

 


Loading...