dent flatbed table top

[bmaine]

Any ideas on how to get dents out of a Mimaki FJFX-200 2513 table top. They are small but effect printing in those areas. Thought about dry ice but looking for experience with this. Thanks.

 

[Gino]

Get a new top ?? How on earth did you get not just one dent, but multiple dents ??

 

[netsol]

can the surface be painted?
is work clamped, or held by vacuum?
if clamped, nitro stan glazing putty & a coat of some sort of sealer or paint

 

[DL Signs]

Best remedy, get yer' check book out, contact Mimaki, and get a replacement top. I've had to replace them on a Fuji I used to run, one of the shop workers brought in a pallet of parts to print, ended up dumping it and put some dents in it. We tried to fix it, but it didn't work so well, affected the vacuum too. If the cost is anywhere near what that was, you won't let another one get dented.