Disintegrating Rubber

[signgirl]

I know I have seen a post in this forum for this without purchasing new. Using gas line to replace? Etched vinyl wrapping? Any ideas would be appreciated!

 

[signgirl]

Sorry, this would be for the gerber GSX plotter arms that hold the vinyl down

 

[Fred Weiss]

It was discussed two days ago at the end of this thread:

http://www.signs101.com/forums/showthread.php?134273-usb-to-serial-converter

 

[signgirl]

Thanks so much Fred! I hope you know how truly appreciated you are!

 

[Hielorojo]

Hello there, a similar/relation question please, how do you clean the "rubber drum" of your plotter, the mine "take a lot of the dust"(my room is clean ) and the dust "glue" over the rubber..........
Thank you in advance.

 

[James Burke]

The drum must be replaced, but the bail arm can have fuel line applied.


JB

 

[jfiscus]

Hello there, a similar/relation question please, how do you clean the "rubber drum" of your plotter, the mine "take a lot of the dust"(my room is clean ) and the dust "glue" over the rubber..........
Thank you in advance.

ThePlotterDoctor has the best rate on replacement drums I have found.

 

[Hielorojo]

Hello there, thank you for your replies,I mean that drum is in good condition but is getting dirty with dust, how can clean off??
Best Regards.

 

[Jase]

The 'fuel' line roller is fairly cheap to replace directly from gerber. The roller on my HS is fairly old and I just cover this in baby talc, works a treat.

 

[signgirl]

I used fuel line for the top and purchased the drum from Plotter Doctor. It's going to be nice not fighting the oily stickiness