artofacks1
New Member
Anyone use the Latex 335 for double sided prints?
Any tutorials or process specific to the 335?
Any tutorials or process specific to the 335?
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Double sided prints latex 335 ?
- Thread starter artofacks1
- Start date
balstestrat
Problem Solver
It doesn't support double sided.
artofacks1
New Member
I hear you it doesn’t.
But what if I printed on one side a repeated graphic that was a background with logo repeated.
Than flip the vinyl and print the front graphic. Doesn’t need to match exactly and align but the back would have a print.
Another idea.
Mark where the print starts on side A. Send to print and than flip it and align it to the mark on side b. In theory shouldn’t the 335 print close to the same Since the 335 always moves forward the same 6” before it starts printing?
Last edited:
balstestrat
Problem Solver
Sure you can do that. Just keep in mind that 1inch marginal on how close you get.
It depends on your settings how much it moves forward.
It depends on your settings how much it moves forward.
artofacks1
New Member
So a 2” bleed all the way around, even a 5” bleed. Hhhmmm
balstestrat
Problem Solver
Yeah exactly. As long as you can get the starting point close you can do it but it depends on you.
And set skew as low as possible so you get it straight.
And set skew as low as possible so you get it straight.