Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Earlier post on "Not Responding" update.

Discussion in 'Graphtec' started by graywoulf, Aug 8, 2012.

  1. graywoulf

    graywoulf Member

    Sep 20, 2009
    Millers Creek, NC
    Well after trying every way to revive my USB connection with my FC7000MK2-75 machine we ordered a serial cable and went the RS-232 route and it worked. Obviously, the USB and the Serial ports are separated on the main board just enough to shield one from another in case of a spike or whatever caused our original problem. I just wish that the Serial cable was twice as long as I had to relocate my cutter to another site which is much less accessible. Now if I could only flash the ROM with the serial cable. Oh well, at least I am back up and cutting vinyl again.

Share This Page