Our Edge FX has been giving us a "fatal error 630" every time we try and print something. The head will lower, act like it's about to print, and then raises the head and then gives us the error. Gerber tech has replaced: motherboard, clutches, z motor, chassis cable, and it still gives the error. The flags are fine so they are not the issue. Does anyone have any ideas?
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Edge FX Fatal Error 630
- Thread starter ESP
- Start date
The Big Squeegee
Long Time Member
Welcome from OK
:Welcome: to :signs101: You might have better luck with your question if you ask it in the forum that deals with that subject. This is the new member welcome forum. How about telling us a little about yourself...
:Welcome: to :signs101: You might have better luck with your question if you ask it in the forum that deals with that subject. This is the new member welcome forum. How about telling us a little about yourself...