Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

enVision 750

Discussion in 'Gerber' started by ndemond, Feb 13, 2008.

  1. ndemond

    ndemond Active Member

    Nov 6, 2007
    For some reason the "tool head" went all the way to the left today and the little ribbon cable (its what I call it)at the bottom has a small tear. It went so far as to hit the material holder arm. After that I got a y axis error. Right now I have a call into Gerber I will hear from them sometime. But in the mean time today I made sure it was still attached and taped the tear down on the cable and it worked the rest of the afternoon.(clear packing tape) I slowed it down manually. Can those little cables be replaced, or is a new tool head needed. If so should I look for a used one. Also not sure why it went to far left. Thanks.

Share This Page