anozira02
New Member
I purchased this Epson Stylus Photo 1400 on Ebay,, not having luck printer accepting the OEM ink cartridges.
If I load the cartridges one by one each time following the instructed by the Status Monitor, after each installation
shows cartridge is full of ink, that is until installing the last cartridge, asking me to install the cartridges shows
them now all with the X, now if I remove one of the cartridge and turn off the printer,, restart. After all that now
it shows all the cartridges ok and asking to install the cartridge I removed. This goes on and on,, just wont
accept the last cartridge. I was thinking maybe it's firmware issue, however I changed mother boards, print head
the CSIC board, checked all connections, changed the panel board. Could use some help if anyone has any idea what's going on..By the way I checked the ink pad counter, which was fine.
If I load the cartridges one by one each time following the instructed by the Status Monitor, after each installation
shows cartridge is full of ink, that is until installing the last cartridge, asking me to install the cartridges shows
them now all with the X, now if I remove one of the cartridge and turn off the printer,, restart. After all that now
it shows all the cartridges ok and asking to install the cartridge I removed. This goes on and on,, just wont
accept the last cartridge. I was thinking maybe it's firmware issue, however I changed mother boards, print head
the CSIC board, checked all connections, changed the panel board. Could use some help if anyone has any idea what's going on..By the way I checked the ink pad counter, which was fine.