Exhaust duct installation

[Paint the Town]

Is this a basic hook up ?

 

[Gino]

Yes, I don't know.


Perhaps telling us a little more of what all is involved with your setup would help a tad.

 

[Paint the Town]

just wondering which of the 3 worked best. fans,ducts or curtain ?

 

[Gino]

Worked best for what ??

In a bathroom possibly all three.

 

[MikePro]

its fairly simple. if you know how to setup a bathroom exhaust, it is not much different than that for your printer.
duct, fan, and a hole in your wall.

 

[Paint the Town]

Thanks MikePro for your imput. Gino get real.

 

[Gino]

Thanks MikePro for your imput. Gino get real.

Thank you.

 

[Paint the Town]

All in fun. I just wanted to get a jump on exhaust install. Getting JV33-160 next week,we went with the exhaust ducts. Just no spec on it or setup.

 

[surf city]

Paint the town, not for nothin I wasn't sure what you really needed either. Wasn't sure if you were looking to vent a printer, a spray booth or like Gino said, a fart fan. Always helps to give as much info as possible.

 

[Paint the Town]

surf city, 1st. time on site. Just figured I had to start somewhere.

 

[Craig Sjoquist]

Well true more info is needed, I would likely look at the manual of printer or website and see what or how much venting is needed, one thing for sure do not go through roof.

 

[Paint the Town]

Craig, I checked web site and site manual for this printer. Its the same old thing, we sell this for that, but no other info. I'm waiting to hear from saleman on this, just wanted to get feed back from users of this type of printer.I have the duct work laid out just dont have specs on o.d.

 

[signcrafters london]

I'm getting ready to partition a separate printing room. So I don't need any kind of solvent barrier or anything in the walls or ceiling? Just vent system?

 

[MikePro]

nothing fancy... just like a bathroom exhaust system.
look into a way to control your environment, as well... humidity and temperature messes with your prints if they vary to the extremes.

dust can ruin beautiful prints as well. print room should be static free and easy to clean (and be kept clean!)

 

[Paint the Town]

Thanks again for your help, MikePro. Still waiting on salesmen to reply. I thought it would be like that. Just sounded to easy. Wanted to make sure.