Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Falcon Outdoor Rear Heat Not Working, can I check volts to see if the board is good?

Discussion in 'Mutoh' started by snommas, Jul 31, 2009.

  1. snommas

    snommas New Member

    Nov 12, 2007
    Recently I noticed my prints were looking strange, I thought it was just a humidity issue, until now when I checked my rear temp.

    It's set at 50 but never gets above 25, I turn it up to 67 with no change.

    Is there a way to check the voltage going to the heater strip so I know what to replace, or that the board if functioning.

    Thanks for your help and a great forum.


Share This Page