GIUSEPPE
New Member
Hi,
does anyone own an FC4210-60 flat bed plotter? I am having difficulty to have the plotter read registration marks on my printed page so that I can cut around my artworks like I do in craft robo. I have Illustrator CS2 installed and also installed the plugin Master Cut 2. Any Suggestions? I have gone through the operation manual step by step, although I must admit it is a bit tedious and frustrating. If there was that same kind of software like the craft robo I am sure things would have been much easier. It is graphtec who are the same suppliers as the Craft Robo so I wonder why they do not have something similar.
Any kind of help is greatly appreciated.
Kind regards and thank in advance anyone with a solution.
does anyone own an FC4210-60 flat bed plotter? I am having difficulty to have the plotter read registration marks on my printed page so that I can cut around my artworks like I do in craft robo. I have Illustrator CS2 installed and also installed the plugin Master Cut 2. Any Suggestions? I have gone through the operation manual step by step, although I must admit it is a bit tedious and frustrating. If there was that same kind of software like the craft robo I am sure things would have been much easier. It is graphtec who are the same suppliers as the Craft Robo so I wonder why they do not have something similar.
Any kind of help is greatly appreciated.
Kind regards and thank in advance anyone with a solution.