Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

FC7000-75 Y position alarm

Discussion in 'Graphtec' started by Neil, Apr 27, 2006.

  1. Neil

    Neil Member

    333
    11
    18
    Aug 25, 2005
    Adelaide, South Australia
    I upgraded the firmware on my new FC7000-75 from 1.01 to 1.52 and now every time I try to do a cross-cut I get a "Y POSITION ALARM" when the carriage presses up against the bar on the left.

    Anyone else encountered this?
    Any ideas how to overcome this problem?
    I don't have the old firmware to revert back to.

    Thanks
     
    Tags:
  2. SSS_Tech

    SSS_Tech New Member

    16
    0
    0
    May 5, 2006
  3. Neil

    Neil Member

    333
    11
    18
    Aug 25, 2005
    Adelaide, South Australia
    Thanks for the reply.
    I did already roll back to a previous version but the problem is still there.
     
  4. Neil

    Neil Member

    333
    11
    18
    Aug 25, 2005
    Adelaide, South Australia
    Okay problem is fixed. Seems it was a coincidence that it started doing this after upgrading the firmware. The problem was the sensor within the cutter head needed adjusting.
     
  5. SSS_Tech

    SSS_Tech New Member

    16
    0
    0
    May 5, 2006
    Good! Glad your up and running.
     
Loading...

Share This Page

 


Loading...