bambino9549
New Member
I have the SW q130 plotter that is the same as the fc7000. Because its the OEM version it will not work with Onyx rip and cut.
I'm trying to flash the firmware and install the fc7000 firmware, I believe that this is the same machine despite what graphtec
would like me to believe. Has anyone came accross this problem and figured out how to get the fc7000 firmware back on the machine?
I refuse to give up on this and I know I,m not the only one out there with this problem.
Thanks for any feed back!!!
I'm trying to flash the firmware and install the fc7000 firmware, I believe that this is the same machine despite what graphtec
would like me to believe. Has anyone came accross this problem and figured out how to get the fc7000 firmware back on the machine?
I refuse to give up on this and I know I,m not the only one out there with this problem.
Thanks for any feed back!!!