FC9000 - Media lock issue

[dinomaskot]

Just got FC9000 and I've noticed that the media lock is not working as it should. Am I doing something wrong or could it be factory defect? (All of the screws are tight)

 

[victor bogdanov]

I've been using Graphtecs for 15 years and have never used that, I've seen the lock on my FC9000 but never even got curious enough to figure out what its for. What's it for?

 

[dinomaskot]

I've been using Graphtecs for 15 years and have never used that, I've seen the lock on my FC9000 but never even got curious enough to figure out what its for. What's it for?

to help you when positioning a roll of vinyl

 

[ikarasu]

You push it to get tension in the roll so it loads straight easily. I never use it, but that's it's intention

 

[victor bogdanov]

You push it to get tension in the roll so it loads straight easily. I never use it, but that's it's intention

Ok I just hold the roll with my right hand and pull will left. I guess good feature for someone short that can't reach over the machine

 

[ikarasu]

90% of what I do is print and cut... So I just press my thumb against the marks until they're in the channel and load that way. Get through a whole roll without any skew.

I used to use it when I had to cut 48" x96" traffic signs on 48.25" material... But nowadays we don't do that.