Smoke_Jaguar
Man who touches printers inappropriately.
Not really seen any good guides for firmware updates on these printers. Every printer I use gives me a message of "Your product has the special version of firmware or It is a product that cannot be updated by this application.", even when in service mode. I can connect to the boards with jumpers and all that stuff and flash them in the much more annoying way, but I imagine there is a simple way to bypass this. The few Mimaki vendors I buy parts from on a regular basis essentially tell me to f-off and go to the seller I bought the new printer from (I almost always buy used, way better deal) when I ask if this is even a service they offer. Is this just related to a value set in the firmware, maybe one in the #Adjust menu? I figure it's little more than a firmware flag preventing the updater doing its work.
