Conor Knoxx
New Member
I was all set to purchase a Fletcher FSC cutter - when I noticed the dimension / space requirements. 100in on a wall / 92 inch free standing.
Where I do my "production" has low ceilings - max of 86 inches (and this is between joists! lol )
So short of moving.... would this still be a usable tool if you hacked 6 inches off the legs? (likely wouldn't bode well for my warranty... but what the heck, live on the edge
)
Otherwise, I guess I'm back to looking for some sort of table-top unit that can cut from 4mm coro on up through diebond/alupanel (open to suggestions!)
Thanks!
Conor
Where I do my "production" has low ceilings - max of 86 inches (and this is between joists! lol )
So short of moving.... would this still be a usable tool if you hacked 6 inches off the legs? (likely wouldn't bode well for my warranty... but what the heck, live on the edge
)Otherwise, I guess I'm back to looking for some sort of table-top unit that can cut from 4mm coro on up through diebond/alupanel (open to suggestions!)
Thanks!
Conor
