Flexi 6.5 over lapping?

[149motorsports]

Is there a tool i can use to over lap 2 seperate peices, say a big flame for a race car that i cut out in 2 peices, with a 1/2 over lap so they look good, instead of cutting the decaling in half by using the knife tool. thanks

 

[cgsigns_jamie]

You can use production manager to "Tile" the graphic and select .5" as your overlap.

 

[149motorsports]

would be able to give me step by step directions. i appreciate your help. thanks

 

[149motorsports]

??????????

 

[J Hill Designs]

production manager --> job properties --> tile tab --> figure it out

 

[cgsigns_jamie]

Sorry I didn't get back to you sooner...

JHill has the right steps... When you're in the Cut/Plot screen click the "Tile" tab at the top. Then on the right side will be all the options for "Tiling" or "Paneling" the graphics. You can then tell the software how much of an overlap you want.

 

[149motorsports]

thanks ill give it a shot!