Flexi feed media back after cut

[SLShop]

I usually use Flexi only for print and cut jobs, but today I tried using it just for vinyl cutting. The only thing that bothered me was that after the cut job, it cuts the vinyl but doesn't retract it. It stays right where it was cut, leaving me with 6 cm of waste when i start a new job. I've already tried using the "advance after plot" function, but it doesn't seem to do anything. This setting must be adjustable somewhere. I'm using a Summa S2.

 

[DonutSlinger]

I have the same issue. Lots of media waste after each job.

 

[Attila Nagy]

Advance after plot sets the next start point after the job, without that the start point would be the same as before the job. You can set panel margin, weeding margin or copy spacing to zero in Flexi. Cut off distance setting is in the cutter.

 

[SLShop]

Whether with or without 'Advance after plot,' it always cuts at the same spot, and the two settings for cutting in Cutter Tools directly don’t have any effect. It seems like Flexi is using a fixed value that cannot be changed. The support team couldn’t help me either.

 

[FrankW]

Have you tried to modify the REPLOT-Setting in the cutter-menu (General Settings)? Regularly Flexi do not send that distance.