Flexi pro 7 question

[4runnerguy]

I have an opportunity to buy a brand new Graphtec CE6000-40 for really cheap. I have been "out of the business" for a few years but I still have a couple different software packages on my computer. I have Flexi pro 7 and Casmate Pro 6.5. Has anyone had experience with creating a design in Flexi then exporting it to the cutting software that comes with these newer cutters, i.e., the Graphtec that I mentioned. I previously had a Roland CX-24 but it died on me and most of the newer cutters use a USB connection which Casmate doesn't support. I called Graphtec and was told that it "should" work by exporting dxf or eps files to the Graphtec cutter software but before I pull the trigger on buying this Graphtec, I would like to be sure. Any help would be greatly appreciated.

 

[GAC05]

The cutting master software that will run your 6000 will work fine with flexi 7 eps files.
If you use CorelDraw or Illustrator it is even easier with the plug-ins (no export).

wayne k
guam usa

 

[4runnerguy]

Thank you for the expedient reply. I only use flexi or casmate, haven't really played with corel or AI.