Flexi Software

[eladgraphics]

Hello
Since Flexi is a rip software, I am wondering if somebody has used it to do color separation or simulated process for screen printing. if so what are the steps and which version did you use. I have flexi 12
thank you

 

[Joe House]

I think the practical difficulties are getting a dense enough print, but you can do it. Load the job into production manager. Open up the job properties and on the color management tab, set up the screen settings that you need (I'm not a screen printer, nor do I play one on TV - so these settings are just defaults from Flexi). This is from Flexi21 - your mileage may vary since your using an older version. I'm pretty sure the separations option is in your version and pretty sure the preview tab isn't.

Then go to the Separations Tab and click on print as separations. The preview shows in color, but the print will be black ink only, unless you also check the box to print separations as color.

Finally, you can go to the Output Channel Preview tab and see what each screen will look like:

Good Luck

 

[eladgraphics]

thanks so much. I am gonna try it now.
appreciate you.