Gerber Edge printing issue

[paul luszcz]

In the middle of a print, our Gerber Edge II started misprinting, leaving streaks all up and down the print area. (see photo attached.)

It was printing 100% then in at a certain point it misprinted about 50%.

It fails with all foils and all vinyls.

I checked all the physical wiring connections and rebooted the computer, but it still persists.

Any ideas on how to resolve?

Paul

 

[Jburns]

Did you remove the dancer bar, and foil squeegee, and check the head connections? Also remove the left side cover, and re-seat upper and lower board connections?

 

[Billct2]

Wow, that's one I haven't seen...hope there is a solution