• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Gerber Sabre 408 & ProfileLab

R

RSC

New Member
Is anyone using ProfileLab to run their Gerber table?

How is it working, any issues with V-Carving or other features?
We are having a heck of a time trying to get it setup and sending the correct depths?

Any tricks or suggestions would be helpful?

Thank you
 
T

Tony Teveris

New Member
I do not know anything about ProfileLab but will assume they are using GCode to command the router. I think the GCode in the Sabre ONLY supports Z initialization from the table top and NOT from any other surface. Now ProfileLab may handle this or not but it's the only thought that pops into my head at the moment.
 
D

Dropout

New Member
What does Profilelab say?

I notice on their website that the Gerber is not one of their supported machines.
 
You must log in or register to reply here.
Top