• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Graphtec CE7000

S

swarnes

New Member
Hi I was watching this video and saw you can print reg marks and tape paper together and cut the sheets instead feeding one sheet at time, can anyone tell me how it is done?
Not using the barcode but using reg marks.
Thanks
 
S

swarnes

New Member
1666704268286.png


I was hoping someone could also help with why contour cut is not allowing copies/job size
thanks
 
B

bigkahuna_305

New Member
swarnes said:
Hi I was watching this video and saw you can print reg marks and tape paper together and cut the sheets instead feeding one sheet at time, can anyone tell me how it is done?
Not using the barcode but using reg marks.
Thanks
Click to expand...
Dosent look like its taped its a sheet of printed material. its not taped together just normal print and cut
 
S

swarnes

New Member
bigkahuna_305 said:
Dosent look like its taped its a sheet of printed material. its not taped together just normal print and cut
Click to expand...
Hi,
they are placing A3 sheets together on the table with tape, I think u need to use cut master in Ai and make sure inch apart from each reg mark but still researching that, any advise welcome, Graphtec support not support using this method, but as its CE7000 it supports reading next set of marks.
 
You must log in or register to reply here.
Top