Graphtec FC-8600-130 contour cutting issues

[rvolkers]

are you using CUTMASTER 4?
have you tried to reset registration marks?
they should be a bit thick and no less than .75
use the regular corner registration marks and ALSO run marks up the sides at least 5 inches apart

on the control panel on the graphtec
make sure that your setting used (condition) is all correct - and that the correct blade#s has been selected for the condition being used an
check all offsets at the panel!

 

[Ministripes]

I have a summa d series and it cuts prints perfect. Got a fc7000mk2-130 and it just doesn't cut printed stickers at all. Can never find the marks. Normal vinyl amazing machine

 

[BigNate]

Was OP able to resolve the problem with the Graphtec? I am curious what the solution was.

 

[Ed. C.]

try a firmware update on your graphtec!
thicken your marks for better reading accuracy

 

[WYLDGFI]

are you using CUTMASTER 4?
have you tried to reset registration marks?
they should be a bit thick and no less than .75
use the regular corner registration marks and ALSO run marks up the sides at least 5 inches apart

on the control panel on the graphtec
make sure that your setting used (condition) is all correct - and that the correct blade#s has been selected for the condition being used an
check all offsets at the panel!

We use Cutting Master sometimes... and have had issues with accurate REFLECTIVE registration.
I want to know how thick are you making your registration marks?