Graphtec FC8600-160 not cutting after reading registration marks

[Perry Propst]

Hello, I'm new to printing then cutting. I set up my registration marks and the FC8600 goes thru and checks them just fine then returns like it is getting ready to cut beeps twice and then the job dissapears from the queue. I don't see any error codes. Any help would be apprciated.

 

[papabud]

the double beep would mean to me there is an error of some kind.
the error wont stay on the display and is gone quickly sometimes.

what software are you using for print cut

 

[Perry Propst]

the double beep would mean to me there is an error of some kind.
the error wont stay on the display and is gone quickly sometimes.

what software are you using for print cut

Thank you, I see the error and it looks like I did not leave enough white space after my registration mark. I'm using Illustrator and Cutting Master 4. I'm reprinting now with more border.

 

[papabud]

ok let us know if this works for you

 

[ikarasu]

You can always expand the area for width white space and it should fix it .If there's not enough direction to read the end... Tape a piece of scrap vinyl to it, and you'll be fine. No need to reprint!