Graphtec FC8600 cutting corners not straight

[sc12345]

Hi Everyone.
I'm just getting my graphtec set up. I'm trying to cut out letters and I noticed that the corners are a little curved. Why? This is my first first thread I'm posting too.Please help

 

[signcrafters london]

Adjust the offset on the cutter until you get sharp corners.

 

[bob]

Hi Everyone.
I'm just getting my graphtec set up. I'm trying to cut out letters and I noticed that the corners are a little curved. Why? This is my first first thread I'm posting too.Please help

Check your blade offset setting. If it's not correct round or over cut [depending] corners will result. Note that once set it never needs revisiting until you change blade diameters.

 

[sc12345]

Thank you for your response!